How to add Securifi ZigBee sensors - Almond+ 2014
This quick guide will help you associate the included sensors that came as part of your beta or developer pledge with your Almond+. Adding other sensors will be similar, but might differ slightly depending on the manufacturer, so please check the included documentation with your sensor.
Contents
Contents
[ Door/Window sensor – SZ-DWS02 1]
[ PIR Sensor – SZ-PIR02 4]
[ Binary on/off switch – SZ-BSW01 7]
[ Flood/water sensor – SZ-WTD01 9]
Door/Window sensor – SZ-DWS02
Start by removing the back of the door/window sensor. This is done by pushing the button marked in the image below and then removing the back of the door/window sensor.
Go in to the association app on the LCD UI of your Almond+ and tap on Associate.
You should now see the following screen.
With the back of the sensor removed, simply press the button that’s highlighted in the picture below to initialize the association process.
Once the sensor has been associated with the Almond+, you should see a screen similar to the one below. Tapping in either text box will allow you to change the name and location of the sensor.
PIR Sensor – SZ-PIR02
Start by removing the back of the PIR sensor. This is done by pushing the button marked in the
image below and then removing the back of the door/window sensor.
Go in to the association app on the LCD UI of your Almond+ and tap on Associate.
With the back of the sensor removed, simply press the button that’s highlighted in the picture below to initialize the association process.
Binary on/off switch – SZ-BSW01
The binary on/off switch has its association button located on the side of the device and as such
there’s no need to open it to associate it with your Almond+.
Start by going in to the association app on the LCD UI of your Almond+ and tap on Associate.
Now simply press the button that’s highlighted in the picture below to initialize the association process. The second button is for manual on/off switching of the device.
Flood/water sensor – SZ-WTD01
Start by removing the back of the flood/water sensor. This can be a bit tricky, as you need a flathead
screwdriver or something similar to pry open the casing with. There are two slots, one on each side, which will help make this easier. You might want to slide something between the lid and the bottom part of the sensor to make it easier to open once you’ve got an opening between the two parts.
Next, go in to the association app on the LCD UI of your Almond+ and tap on Associate.
With the top of the sensor removed, simply press the button that’s highlighted in the picture below to initialize the association process.
Once the sensor has been associated with the Almond+, you should see a screen similar to the one below. Tapping in either text box will allow you to change the name and location of the sensor.
