View source for First Alert Smoke & CO Detectors

== From First Alert Manual ==
• The alarm will operate with 3rd party, certified Z-Wave devices. Basic
command class required by all Z-Wave devices. By the requirements of
the Device Class spec, this command class does not have to be mapped
to any particular functionality for this device.

== INCLUSION ==
# Slide battery door open.
# Insert batteries checking the correct orientation.
# Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.

== EXCLUSION ==
# Slide battery door open.
# Remove and re-insert batteries checking the correct orientation.
# Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.
* The alarm will remain awake for 30 seconds on inclusion.
* The alarm supports one association group with up to 5 nodes, and sends its alarms to that group.
* The alarm supports configuration parameter #1, which has a size of 1, a default value of 0, and when set to 1 causes the device to send double alarm messages.

== RESET DEVICE ==
If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device
will not remain awake after resetting and will go into standby mode.