View source for NYCE NCZ-3202

[[Category:Sensors]]

<big><big>'''Please follow the below instructions on how to add/remove the NYCE NCZ-3202 to Almond :'''</big></big> 

[[File:4bkeyfob.png|frameless|350px]]


'''Adding:'''                                                                                                  


Tap on “'''Add Sensors-->Add'''” on Almond to keep it in pairing mode and search for the sensor.

[[File:Add 2.png|frameless|350px]]


Now, on the KeyFob press the button 1 and 2 then press button-1  6(Six) times to leave the network, if your KeyFob is added to other hub previously, if it is the first time setup you could ignore this step.

Now, Press the button 1 and 2 and then press button-1  4(Four) times to join the network.

Note: If you want to reset the Key Fob, please press the button 1 and 2 and then press button-1  10(Ten) times to Reset the sensor.

While the Keyfob is adding to the Almond, you would receive the following message on the Almond Screen and Sensor gets paired to Almond:


[[File:Add 3.png|frameless|350px]]

Bulb is successfully added/paired with the Almond and could be controlled via Almond LCD Screen or Almond app.


'''Remove:''' 


On your Almond LCD screen tap on “Add Sensor” icon and tap on “Remove” (Not on “Remove all sensors”), Almond would be in exclusion or removal mode as shown below in the picture:


[[File:remove.jpg|frameless|350px]]


Now, please press the button 1 and 2 and then press button-1  10(Ten) times to Reset the sensor. You would see the below message when the sensor is removed from the Almond.


[[File:remove1.jpg|frameless|350px]]


Sensor is successfully removed from the Almond.


OEM Link: http://nycesensors.com/products/