Difference between revisions of "Utilitech TSE07-1"
SecureComp (Talk | contribs) (Utilitech TSE07-1 Siren details) |
SecureComp (Talk | contribs) m |
||
| (3 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | Utilitech TSE07-1 Siren with Red Strobe/Flashing LED | + | '''Utilitech TSE07-1 Siren with Red Strobe/Flashing LED''' |
Z-Wave™ Compatible | Z-Wave™ Compatible | ||
Sold at Lowes | Sold at Lowes | ||
| Line 5: | Line 5: | ||
Identical to Everspring SE812 | Identical to Everspring SE812 | ||
| − | Siren and Red Strobe triggered together. No way to separate them yet, if ever. | + | Siren and Red Strobe ''triggered together''. No way to separate them yet, if ever. |
| − | User selectable sound level via jumper pin inside battery compartment, 100 or | + | '''User selectable sound level''' via '''jumper pin''' inside battery compartment, '''100 or 90 decibels'''. |
| − | Can be powered by battery or DC 6Volt source. | + | Can be powered by '''battery or DC 6Volt source'''. |
User tested to work with Almond+ | User tested to work with Almond+ | ||
| + | |||
| + | |||
| + | |||
| + | '''PAIRING''' | ||
| + | |||
| + | Install batteries in Utilitech Siren | ||
| + | |||
| + | Place Almond+ in Z-Wave Add Sensor Mode | ||
| + | |||
| + | Press Siren Test button until you hear beep (1 second), release Test button | ||
| + | |||
| + | Complete Sensor Add dialog on Almond+ | ||
| + | |||
| + | |||
| + | '''RESET PAIRING''' | ||
| + | |||
| + | If ''Pairing device to a different Hub'', you must perform a ''Reset by pressing the Pair Button (Test button) 8 times, one second apart''. | ||
| + | |||
| + | Then proceed with standard Pairing instructions | ||
Latest revision as of 00:40, 6 June 2015
Utilitech TSE07-1 Siren with Red Strobe/Flashing LED Z-Wave™ Compatible Sold at Lowes
Identical to Everspring SE812
Siren and Red Strobe triggered together. No way to separate them yet, if ever.
User selectable sound level via jumper pin inside battery compartment, 100 or 90 decibels.
Can be powered by battery or DC 6Volt source.
User tested to work with Almond+
PAIRING
Install batteries in Utilitech Siren
Place Almond+ in Z-Wave Add Sensor Mode
Press Siren Test button until you hear beep (1 second), release Test button
Complete Sensor Add dialog on Almond+
RESET PAIRING
If Pairing device to a different Hub, you must perform a Reset by pressing the Pair Button (Test button) 8 times, one second apart.
Then proceed with standard Pairing instructions
