Difference between revisions of "First Alert Smoke & CO Detectors"
From SecuriWiki
(Created page with "== From First Alert Manual == • The alarm will operate with 3rd party, certified Z-Wave devices. Basic command class required by all Z-Wave devices. By the requirements of t...") |
|||
| (One intermediate revision by one user not shown) | |||
| Line 5: | Line 5: | ||
to any particular functionality for this device. | to any particular functionality for this device. | ||
| − | == | + | == Inclusion/Adding == |
# Slide battery door open. | # Slide battery door open. | ||
# Insert batteries checking the correct orientation. | # Insert batteries checking the correct orientation. | ||
# Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button. | # Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button. | ||
| − | == | + | == Exclusion/Removing == |
# Slide battery door open. | # Slide battery door open. | ||
# Remove and re-insert batteries checking the correct orientation. | # Remove and re-insert batteries checking the correct orientation. | ||
| Line 18: | Line 18: | ||
* The alarm supports configuration parameter #1, which has a size of 1, a default value of 0, and when set to 1 causes the device to send double alarm messages. | * The alarm supports configuration parameter #1, which has a size of 1, a default value of 0, and when set to 1 causes the device to send double alarm messages. | ||
| − | == | + | == Resetting the device == |
If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device | If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device | ||
will not remain awake after resetting and will go into standby mode. | will not remain awake after resetting and will go into standby mode. | ||
Latest revision as of 05:55, 12 January 2015
From First Alert Manual
• The alarm will operate with 3rd party, certified Z-Wave devices. Basic command class required by all Z-Wave devices. By the requirements of the Device Class spec, this command class does not have to be mapped to any particular functionality for this device.
Inclusion/Adding
- Slide battery door open.
- Insert batteries checking the correct orientation.
- Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.
Exclusion/Removing
- Slide battery door open.
- Remove and re-insert batteries checking the correct orientation.
- Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.
- The alarm will remain awake for 30 seconds on inclusion.
- The alarm supports one association group with up to 5 nodes, and sends its alarms to that group.
- The alarm supports configuration parameter #1, which has a size of 1, a default value of 0, and when set to 1 causes the device to send double alarm messages.
Resetting the device
If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device will not remain awake after resetting and will go into standby mode.
