Difference between revisions of "First Alert Smoke & CO Detectors"
From SecuriWiki
(Created page with "== From First Alert Manual == • The alarm will operate with 3rd party, certified Z-Wave devices. Basic command class required by all Z-Wave devices. By the requirements of t...") |
m (Automate moved page First Alert Smoke & CO Detector to First Alert Smoke & CO Detectors) |
(No difference)
| |
Revision as of 17:45, 30 December 2014
From First Alert Manual
• The alarm will operate with 3rd party, certified Z-Wave devices. Basic command class required by all Z-Wave devices. By the requirements of the Device Class spec, this command class does not have to be mapped to any particular functionality for this device.
INCLUSION
- Slide battery door open.
- Insert batteries checking the correct orientation.
- Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.
EXCLUSION
- Slide battery door open.
- Remove and re-insert batteries checking the correct orientation.
- Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.
- The alarm will remain awake for 30 seconds on inclusion.
- The alarm supports one association group with up to 5 nodes, and sends its alarms to that group.
- The alarm supports configuration parameter #1, which has a size of 1, a default value of 0, and when set to 1 causes the device to send double alarm messages.
RESET DEVICE
If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device will not remain awake after resetting and will go into standby mode.
