First Alert Smoke & CO Detectors

From First Alert Manual

• The alarm will operate with 3rd party, certified Z-Wave devices. Basic command class required by all Z-Wave devices. By the requirements of the Device Class spec, this command class does not have to be mapped to any particular functionality for this device.

INCLUSION

1. Slide battery door open.
2. Insert batteries checking the correct orientation.
3. Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.

EXCLUSION

1. Slide battery door open.
2. Remove and re-insert batteries checking the correct orientation.
3. Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button.

• The alarm will remain awake for 30 seconds on inclusion.
• The alarm supports one association group with up to 5 nodes, and sends its alarms to that group.
• The alarm supports configuration parameter #1, which has a size of 1, a default value of 0, and when set to 1 causes the device to send double alarm messages.

RESET DEVICE

If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device will not remain awake after resetting and will go into standby mode.